Wholesale price stable quality 12″ rubber glove with cotton linning-rough finish sale to Naples

FAQ Content

This is a Re-Uploaded video that i had on youtube. Due to a song i used they removed it. 60k+ views Now we start over

Making a crappy wheel look less crappy. In the end you still have a rota!

Song by: http://soundcloud.com/bcjdmdecalscom/andre-mildh-hiphop2
Paint Stripper: KLEAN-STRIP AIRCRAFT REMOVER
Part Number: #AR 343
Where to purchase: Anywhere they sell automotive paint.
Price: $35.00
Additional Info:
This video is not a DIY. The video was more less filmed for fun. Gave me a reason to use my Canon XL1s.

Idea of video:
Countless times i have seen on various honda forums of DIY tips on how to strip your wheels. This process being so simple, there are still members asking questions.. How long does it take, do you have to pressure wash it off, what about gloves.

This video is simple, shows how honestly this process is. Its just wipe on and off.

worried about your hands? Then wear chemical gloves, or just don’t get anything on your hands.

The ONLY tip that i can give, that i feel many dont know is…

If you noticed in the first min or so of the video, i keep applying layers of the stripper. That is because as im doing that, the stripper is begin absorbed into the paint, making it peel off. If you keep putting fresh layers of stripper, it will keep pulling the paint.

Im sure most of you know that, but.. for those of you that like to read up on everything before you do anything on your own.. thats my tip.

The video is LONG i know, the idea is to show a realistic timeframe in a speed video of how long this takes.

The reason I did not use the spray Aircraft Stripper, is because of a couple reasons.

1. It takes about 1 spray can per wheel.
2. After you spray it on, you still need to bust out some type of brush to make sure it makes it in all the small crevices.
3. I can do all 4 wheels with 1 8$ can found at Walmart.
4. There is no over spray, or splatter with the brush method.

Follow this video clip information to find out how to form, mildew, and pour your own custom climbing holds! Built from basic customer components, nevertheless build high quality cheap holds. Products shown underneath

*Ive actually upgraded to t-nuts and SHCS now so my procedure is up-to-date a bit from the video clip. I drill the bolt hole in the foam a little, as nicely as a bigger counter bore for the bolt head. When I layer the silicone on the foam, I push a very good bit down into the bolt hole. The mildew dries and the bolt hole produces a nipple in the negative mildew. I then location a 3/eight washer on this nipple in advance of pouring the resin, so the bolt head is bolstered.

Substance Wanted:
-Dry Floral Foam
-a hundred% Very clear Silicone
-Dish Cleaning soap
-Cheese Fabric
-Fiberglass Resin
-Sheetrock Sand Additive
-Oil Based paint