Manufacturer for 14″ Household rubber glove to belarus Factory

FAQ Content

http://www.Dexpan.com Save Money! Three Easy Steps for Concrete Demolition, Rock Breaking, Excavating: How to Break Rocks, Concrete Easily with Dexpan Expansive Demolition Grout. Three Easy Steps to Break Rocks and Concrete. When using Dexpan non-explosive demolition agent to demolish mass reinforced concrete or rock, there are only 3 Easy Steps to Succeed: Drill, Mix and Pour.
1) Drilling:
Use 1.5 inches (3.8 cm) drill bit, holes should be drilled 1 ft (30 cm) apart.
80-90% of the depth, DO NOT go through.
2) Mixing:
In a bucket, combine 0.4 gallons (1.5 liters) of water with one 11 lb. (5 kg.) bag.
Mix well to a slurry. (a drill and paddle is recommended)
3) Filling: *Warning: Use of Dexpan in extreme hot temperatures could cause blowouts.
Dexpan® slurry should be poured into holes within 10-15 minutes after mixing.
Coverage: Normally one 11 lb. (5 kg.) bag can fill up to 9 lineal feet (2.5 meters).
4) Cracking Or Cutting Time:
Properly mixed, the cracks may appear after 2-8 hours. Allow 24 hours for best results.
**WARNING** IMPORTANT SAFETY PRECAUTIONS and FIRST AID:
SAFETY GOGGLES, RUBBER GLOVES and DUST-PROOF MASK is required.
**WARNING** BLOWOUTS may occur! DO NOT look directly into filled holes.
Do not breathe in dust. Avoid eye and skin contact. If eye or skin contact should occur, rinse it off IMMEDIATELY with plenty of water and consult doctor.
Choose correct type of Dexpan® based on rock / concrete temperature.
Keep Dexpan® in DRY storage. Seal box / bag after use.
Keep out of reach of children and pets.
How to Break Rocks and Concrete Easily with Dexpan. Rock Breaking, Concrete Cutting, Concrete Demolition Grout.

Watch more Housekeeping Tips videos: http://www.howcast.com/videos/329185-How-to-Clean-Antique-Brass

The first step in restoring brass is a good cleaning but, though you want to be tough on dirt and grime, you want to go easy on this precious metal.

Step 1: Determine if brass is lacquered
Determine whether your brass is lacquered, and whether to clean over the lacquer or to remove the lacquer and clean the brass beneath it.

Tip
If a piece is particularly valuable, consult a specialist or curator before attempting to clean it.

Step 2: Start with soapy water
Clean unlacquered brass with hot soapy water and a soft cotton cloth, wearing rubber gloves to protect your hands. Dampen the cloth, wipe down your brass, and then dry it immediately with a fresh cloth.

Step 3: Boil linseed oil
Boil linseed oil and apply to a clean cloth. Wipe the brass again to remove lingering dirt or oils that have built up on the surface, and buff it dry.

Step 4: Make a paste
Make a paste with equal parts vinegar, salt, and flour if your brass is plagued with stubborn grime. Apply the paste and let it set for an hour or two.

Step 5: Remove paste
Remove the paste with warm water and then dry your brass with a clean, soft cloth. Repeat paste applications if necessary.

Step 6: Maintain
Remove tarnish that builds up. Clean and polish your brass regularly. Lacquer the brass.

Did You Know?
There are 31 tons of copper in the Statue of Liberty.