Factory Promotional 32″ Large cuff rubber glove Wholesale to California

FAQ Content

Check out these new kinds and additional from Zappos.com! http://zps.to/ShopZappos
Subscribe & see additional! http://zps.to/SubscribeShopZappos
Everything is coming up roses with the excellent Rain Boot Rosey boot from Bogs®!
100% water-resistant.
Ultra soft and flexible all-natural rubber higher.
Light-weight puddle jumper.
Pull-on handles for easy off-and-on.
Max-Wick™ moves dampness absent to preserve your toes dry and new.
Twin-density EVA insole features DuraFresh anti-odor defense for a fresher foot ecosystem.
Rubber outsole with tread sample helps prevent slipping.
Imported.
Measurements:

Body weight: one lb one.8 oz
Circumference: sixteen in
Shaft: ten in

Join with Zappos:
Check out our other channel! https://www.youtube.com/ZapposGear
Stick to Zappos on Twitter & Instagram! @zappos
Pin with us! https://www.pinterest.com/zappos
Be our close friend on Facebook! https://www.fb.com/zappos
Go Past the Box! https://www.zappos.com/blogs

View in 1080 for clear images!

Song: Blackmill – Spirit of Life

This is primarily a slideshow containing some of the photos I took during my refinishing of a 1933 Mosin Nagant. It took several months, but the final result was worth the work.

If I had to do it all over again, here is what I would do:

Supplies:
Foaming Varnish Stripper Aerosol
Thick Rubber Gloves
Large Plastic Tub (preferably long enough to fit the entire rifle to rinse in hot water)
Sandpaper from 180-1000 Grit minimum
Oil-Based Stain
Cheesecloth
Tack Cloth
Formby’s Tung Oil Finish High Gloss
0000 Steel Wool
Car Wax
Birchwood Casey Cold Blue Kit
Gun Cleaning Supplies

Begin by disassembling the rifle completely.
Boil any metal parts to remove cosmoline. Flush the barrel with boiling water.
Use a brass brush and gun cleaner to scrub away any rust on large parts
Use CLR or Birchwood Casey Rust Remover on small parts
Re-Blue small screws and touch-up blue large parts where rusted.
Use stripper on both wooden parts to remove surface finish
Rinse wood with hot water
Allow wood to dry thoroughly at room temperature (~1 week)
Place wooden parts in oven on a very low “broil” setting with oven door open
Wipe any foaming cosmoline from the wood and occasionally rotate parts
Once satisfied with cosmoline removal, perform one final cleaning using a degreaser such as Simple Green to remove any surface cosmoline (the more cosmoline you remove now, the less your wood will darken with time).
Sand all wooden parts to 1000 grit
Apply 2 coats of stain, followed by 6 coats of Formby’s
To get a super-smooth finish, apply several thick coats of finish without steel wool then re-sand the whole stock. This fills in any wood pores or divots. Continue applying finish as desired.
Do not sand the final coat. Apply car wax to protect finish.
Re-assemble rifle carefully!!!! The metal rings must slide down your brand new finish to lock into place. I damaged my finish slightly by rocking the rings back and forth – creating a slight drivot each time. Sucks.

Your $90 Mosin Nagant now looks like a $150 Mosin Nagant, congratulations!

Blackmill has stated on his music videos that he does not mind the use of his songs in other videos as long as credit is given.

He and his music kick serious ass, check out his channel and buy his songs!

http://www.facebook.com/pages/Blackmill/167224433307649

http://www.youtube.com/user/blackmillmusic