Factory making 26” Industrial rubber glove-smooth finish Wholesale to Greece

Short Description:

26”length (65-67cm), black, smooth finish, seamless, no cotton lining, left/right hand, 700g/pair, cuff perimeter:61cm, double layer thickness:2.2mm. 50 pairs/case, carton size: 74*36*44cm. Net weight: 35kg/case, gross weight: 37kg/case. It can be suitable used for sand blasting cabinet operation.


Product Detail

FAQ

Product Tags

Our development depends on the advanced equipment ,excellent talents and continuously strengthened technology forces Factory making 26” Industrial rubber glove-smooth finish Wholesale to Greece, Standing still today and looking into the future, we sincerely welcome customers all over the world to cooperate with us.


26”length (65-67cm), black, smooth finish, seamless, no cotton lining, left/right hand, 700g/pair, cuff perimeter:61cm, double layer thickness:2.2mm. 50 pairs/case, carton size: 74*36*44cm. Net weight: 35kg/case, gross weight: 37kg/case. It can be suitable used for sand blasting cabinet operation.

  • Previous:
  • Next:
  • FAQ Content




  • Slip these flexible wintertime boots from Guess on for an effortless, stylish glimpse that will fit any outfit. http://www.heels.com/womens-footwear/hearne-black-suede.html



    In this lifecasting tutorial video, we demonstrate how to use alginate to make a mold of a hand.

    Step One: Measure and Mix
    Mix Ratio: 1 part Alja-Safe to 1 part water by volume. Add first cup of Alja-Safe and begin mixing. Add second and third cups of Alja-Safe. Mix to a creamy consistency, no lumps.

    Step Two: Pose Hand and Immerse Slowing into the Alja-Safe
    Wet the model’s hand before placing it into the Alja-Safe. Keep hand 1/2 inch (1.27 cm) above the bottom of the container. Let Alja-Safe set for 8-10 minutes, until solid.

    Step Three: Demold
    Slowly and carefully remove hand. Removing the model too fast may result in a tear in the mold. Ready to cast.

    Step Four: Casting into the Alja-Safe Mold with Smooth-Cast 300Q Ultra-Fast Urethane Resin
    Apply Universal Release Agent. Dispense Part A. Dispense Part B. Combine both parts in mixing container. Mix thoroughly. Rotate mold to minimize air entrapment. Plastic will cure in less than one minute.

    Step Five: Demold the Resin Casting
    Perfectly detailed reproduction. Apply primer. Apply paint.

    How long did it take to make the mold?
    Start to Finish: 25 Minutes

    How long did it take to make the casting?
    Start to Finish: 15 Minutes

    How much Alja-Safe was used?
    Less than 1 lb (0.45 kg)

    Use Your Imagination:
    * Cold Cast Metal Effects
    * Create Different Color Effects
    * Clear Resin Effects (additional mold making & casting required)

    Starter Kit Available at: http://www.smooth-on.com/Getting-Started-Li/c4_1219/index.html

    Make It Now! with Smooth-On

    http://www.smooth-on.com/

    http://www.facebook.com/SmoothOn

    http://twitter.com/SmoothOn

    http://www.google.com/+smoothon

    Send your message to us:

    INQUIRY NOW
    • [cf7ic]

    Related Products

    INQUIRY NOW
    • [cf7ic]