50% OFF Price For 24″ rubber glove – cotton linning-rough finish to Slovakia Factories

FAQ Content

Gogopress Provide Rubber Real Color Imprinted Media for Logo Heat Transfer on Fabric or Garment,
The Better choice for Fabric Label Heat Transfer Printing with NO MOQ for your Custom Design,
GOGOPRESS Real Imprint presents newest Rubber Color Heat Transfer Media. It is a kind of iron-on Heat Transfer Imprint, hot-melt urethane in rubber sheet stick to object, which applies to all fabrics, either natural or chemical fabrics, light or dark background of target fabrics. Such as 100% cotton or cotton blend, silk, linens, nylon, brocade, rough yam, tweed, twill etc.

final products with super Best images are easily and quickly printed and cut with features of gentle handles, up to 1440dpi resolution, Highly water, Wash scratch and fade resistant and environment friendly.
To obtain best results, Real Imprinted ECO-SOL ink is recommended.
No Minimum request, Free Sample Provide Small order export is welcome…..

Be cautious when holding key components that have sensitive contact areas. If you want to be extra cautious you can use tech grade ESD gloves. I recommend ESD Nitrile gloves that have microtextured fingertips that provide excellent grip on all surfaces. 100% nitrile gloves contain no natural rubber or silicone and meet stringent requirements for particles and extractables. In regards to handling try not to directly handle PCB or contact points. For a graphics card try to handle it from the corners or the heatsink. For a motherboard use the corners / sides. If you do not want to use full gloves you can also consider finger ESD cods. If you use your bare hands just have common sense and keep in mind when the contacts are.

I mistakenly refer to the measurement on the gloves thickness as millimeters, when in fact it is milli-inches. MIL stands for milli-inches and MM stands for millimeters. My bad. Though, that doesn’t change anything I say as inaccurate regarding smaller number = thinner glove.

ESD Nitrile Gloves:

http://amzn.to/2rbxvVN

If you’re trying to prevent fingerprints, wash your hands thoroughly with soap and water, paying particular attention to scrubbing the pads on your fingers. Dry them off well. Then handle the components by the edges, as I demonstrate in all of my computer building videos. If you happen to see a fingerprint, stop. Go wash your hands again! This is a much better plan than using any kind of glove.

Remember, handle all parts by the edges and there is no place for fingerprints to be left behind! I demonstrate this in every single computer build video I’ve ever done.

If you’re trying to prevent cuts, these gloves are all too thin to provide any protection from that. Work slower and more carefully to avoid injury. Or put on band-aids prematurely in areas of your hands that you feel you are most prone to be cut.

Video editing software used to create this video:
Cyberlink PowerDirector 15 Ultimate:

https://www.cyberlink.com/products/powerdirector-ultra/

Screen captures by Camtasia Studio 9:

https://www.techsmith.com/camtasia.html

Questions?

https://www.facebook.com/careyholzmanfanpage

See more of Carey’s video’s here:

http://www.CareyHolzman.com