28 Years Factory 26” Industrial rubber glove-smooth finish to Ukraine Manufacturer
Short Description:
26”length (65-67cm), black, smooth finish, seamless, no cotton lining, left/right hand, 700g/pair, cuff perimeter:61cm, double layer thickness:2.2mm. 50 pairs/case, carton size: 74*36*44cm. Net weight: 35kg/case, gross weight: 37kg/case. It can be suitable used for sand blasting cabinet operation.
Product Detail
FAQ
Product Tags
In the past few years, our company absorbed and digested advanced technologies both at home and abroad. Meanwhile, our company staffs a team of experts devoted to the development of products. 28 Years Factory 26” Industrial rubber glove-smooth finish to Ukraine Manufacturer, winning customers' trust is the gold key to our success! If you are interested in our products, please feel free to visit our web site or contact us.
26”length (65-67cm), black, smooth finish, seamless, no cotton lining, left/right hand, 700g/pair, cuff perimeter:61cm, double layer thickness:2.2mm. 50 pairs/case, carton size: 74*36*44cm. Net weight: 35kg/case, gross weight: 37kg/case. It can be suitable used for sand blasting cabinet operation.
FAQ Content
Black nitrile
Powder-free
5 mil thickness
9.5” rolled cuff
CFIA approved
100 gloves/dispenser
In this lifecasting tutorial video, we demonstrate how to use alginate to make a mold of a hand.
Step One: Measure and Mix
Mix Ratio: 1 part Alja-Safe to 1 part water by volume. Add first cup of Alja-Safe and begin mixing. Add second and third cups of Alja-Safe. Mix to a creamy consistency, no lumps.
Step Two: Pose Hand and Immerse Slowing into the Alja-Safe
Wet the model’s hand before placing it into the Alja-Safe. Keep hand 1/2 inch (1.27 cm) above the bottom of the container. Let Alja-Safe set for 8-10 minutes, until solid.
Step Three: Demold
Slowly and carefully remove hand. Removing the model too fast may result in a tear in the mold. Ready to cast.
Step Four: Casting into the Alja-Safe Mold with Smooth-Cast 300Q Ultra-Fast Urethane Resin
Apply Universal Release Agent. Dispense Part A. Dispense Part B. Combine both parts in mixing container. Mix thoroughly. Rotate mold to minimize air entrapment. Plastic will cure in less than one minute.
Step Five: Demold the Resin Casting
Perfectly detailed reproduction. Apply primer. Apply paint.
How long did it take to make the mold?
Start to Finish: 25 Minutes
How long did it take to make the casting?
Start to Finish: 15 Minutes
How much Alja-Safe was used?
Less than 1 lb (0.45 kg)
Use Your Imagination:
* Cold Cast Metal Effects
* Create Different Color Effects
* Clear Resin Effects (additional mold making & casting required)
Starter Kit Available at: http://www.smooth-on.com/Getting-Started-Li/c4_1219/index.html
Make It Now! with Smooth-On
http://www.smooth-on.com/
http://www.facebook.com/SmoothOn
http://twitter.com/SmoothOn
http://www.google.com/+smoothon
