2016 Good Quality 12″ rubber glove with cotton linning-rough finish supply for Qatar
Short Description:
Heavy duty rubber glove, made of 100% natural latex. 12″ length(31cm), rough finish, seamless, cotton lining, left/right hand, 210g/pair, 120pairs/case. Using for Isolater, dry box, blast cabinet, glove box, etc.
Product Detail
FAQ
Product Tags
The key to our success is "Good Product Quality, Reasonable Price and Efficient Service". 2016 Good Quality 12″ rubber glove with cotton linning-rough finish supply for Qatar, With a wide range, good quality, reasonable prices and good service, we will be your best business partner. We welcome new and old customers from all walks of life to contact us for future business relationships and achieving mutual success!
Heavy duty rubber glove, made of 100% natural latex.
12″ length(31cm), rough finish, seamless, cotton lining, left/right hand, 210g/pair, 120pairs/case.
Using for Isolater, dry box, blast cabinet, glove box, etc.
FAQ Content
In this lifecasting tutorial video, we demonstrate how to use alginate to make a mold of a hand.
Step One: Measure and Mix
Mix Ratio: 1 part Alja-Safe to 1 part water by volume. Add first cup of Alja-Safe and begin mixing. Add second and third cups of Alja-Safe. Mix to a creamy consistency, no lumps.
Step Two: Pose Hand and Immerse Slowing into the Alja-Safe
Wet the model’s hand before placing it into the Alja-Safe. Keep hand 1/2 inch (1.27 cm) above the bottom of the container. Let Alja-Safe set for 8-10 minutes, until solid.
Step Three: Demold
Slowly and carefully remove hand. Removing the model too fast may result in a tear in the mold. Ready to cast.
Step Four: Casting into the Alja-Safe Mold with Smooth-Cast 300Q Ultra-Fast Urethane Resin
Apply Universal Release Agent. Dispense Part A. Dispense Part B. Combine both parts in mixing container. Mix thoroughly. Rotate mold to minimize air entrapment. Plastic will cure in less than one minute.
Step Five: Demold the Resin Casting
Perfectly detailed reproduction. Apply primer. Apply paint.
How long did it take to make the mold?
Start to Finish: 25 Minutes
How long did it take to make the casting?
Start to Finish: 15 Minutes
How much Alja-Safe was used?
Less than 1 lb (0.45 kg)
Use Your Imagination:
* Cold Cast Metal Effects
* Create Different Color Effects
* Clear Resin Effects (additional mold making & casting required)
Starter Kit Available at: http://www.smooth-on.com/Getting-Started-Li/c4_1219/index.html
Make It Now! with Smooth-On
http://www.smooth-on.com/
http://www.facebook.com/SmoothOn
http://twitter.com/SmoothOn
http://www.google.com/+smoothon
http://www.trend-fashion.com.pl/en/12-all-natural-rubber-latex/30-stockings/transparent-latex-stockings-sizes-s-xxl-data
http://www.trend-fashion.com.pl/12-latex-naturalny/30-ponczochy/ponczochy-lateksowe-transparent-rozmiary-od-s-xxl-data