15 Years Manufacturer 32″ rubber glove-cotton linning Marseille Factory

FAQ Content

This is not a quick project allow yourself a full day. This will also take 8 weeks to cure so you will not be able to use or sell it for at least that time period. The best soaps are aged a year for hardness. But that isn’t always necessary in this day and age as we are much better with the science of caustic ingredients. Refresher or newer the soap is the faster it will dissolve in Your Shower.

Supplies : Large ceramic coated canning pot, 1 gallon deep glass jar, thermometer, stainless steel whisk, wooden spoon, rubber gloves (heavy duty), safety glasses, apron, and your molds.

Ingredients: 5-7 cups of cold water or milk, 12 – 13 ounces of 100% lye (sodium hydroxide.)

PUT ON YOUR RUBBER GLOVES AND OTHER SAFETY GEAR!!

Measure your life on something flexible like a paper plate be very cautious with it. Add your milk or water to your glass jar. Gently pull into your milk or water. Stir gently and do this in a well-ventilated area. Check the temperature should be between 140 and 160 degrees. Allow temperature to reduce down to 90 degrees this could take a couple hours.

Ingredients: 1 quart of tea your choice, or water 5 – 6 pounds of lard

Add this to large ceramic coated canning pot. Put it over stove on low heat to melt to a liquid state of 125 degrees. This temperature needs to be maintained until I mixture reduces down to 90 degrees.

Once the lye mixture has reached with 90 degrees and the lard mixture has reach 125 degrees you may add the lye to your large ceramic pot of lard and water. Pour gently careful not to Splash. Begin stirring immediately very gently again not to Splash.

TIP: changing directions in your stirring will cause splashing!

There is no need to stir continuously through this process but you will need to stir until it reaches a smooth looking liquid. At that point it is just a matter of time. Check it periodically to stir.

Ingredients: 6 ounces of coconut oil, .5-1 ounce of essential oil, 1/2 tablespoon. of litsea, 1 tsp of grape seed extract or vitamin E, 1/2 oz crushed herb or coffee powdered, 1 tablespoon of benzene.

When it begins to emulsify or reaches the state of tracing (which is gentle peaks staying where you stir the spoon.) You may add you are 6 ounces of coconut oil, grape seed extract essential oils benzene and herbs.

Once this is thoroughly mixed and it is thickening you may pour it into your Mold or molds.
After 24 hours it may be removed from the mold In about a week you may slice your soap to size desired.
Washer hands at after handling the soap at this stage.

YOU MUST ALLOW 8 WEEKS TO CURE!
There is still free lye within the product and it can cause burning

Part One of Two
A customer, who works in a hospital, inquired if our SuperShells would be safe to clean with Lysol wipes with bleach. Since we didn’t know the answer to her question we decided to break out the industrial strength rubber gloves and do some SCIENCE! Here we tested five SuperShells in rubbing alcohol, Lysol, Bleach, turpentine and acetone. Leaving one piece in for just a second or so, one in for an hour and one in for over a week. When done we will compare all of the pieces with the control piece to see if there has been any change to the closed-cell foam.
M-Edge SuperShells for iPad and iPhone are available at various retail stores and on our website:

http://www.medgestore.com/products/ipad2-supershell.psp?device=ipad4

http://www.medgestore.com/products/iphone4-supershell.psp

http://www.medgestore.com/products/iphone5-supershell.psp?device=iphone5